EM5 Embedding Molds

Description

Features
Separate base and tube sections that clip together to form the familiar capsule shape
Care should be taken that each component is free of debris before attaching together, to ensure a proper seal
Easy removal of resin blocks achieved by simply pulling the mold apart by hand
The mold can produce blocks up to 20mm in length, however shorter blocks (˜14 mm) allow for easier removal. No razor blades or capsule presses are required
The detachable cap section allows for easier access and manipulation of a specimen
For more accurate specimen alignment a small amount of resin can be cured or partially cured before clipping to the body and completing the resin block. When fully cured they form strong homogeneous blocks
Each mold can be clipped to other molds, allowing for the creation of trays of desired size. For volatile resins, another cap section can be clipped on to the top of the mold, creating an air tight seal
Each cavity is numbered 1 < 5, whilst the end support stands have designated areas for writing indexing numbers or comments